PhiLink

PhiLink sends a pattern from your phone or computer screen straight to your earring. No cable and no app: the screen flashes a coded light signal, and the earring reads it.

Compatibility: PhiLink only works with Fibonacci 2.0 earrings, or Amoracci shipped after October 2026. It does not work with earlier Fibonacci earrings or with Amoracci shipped earlier. Not sure which you have? Contact us before sending.
How to check: press the earring button to step through the modes. Earrings with PhiLink have a 7th mode, RECEIVE, after Manual.
PhiLink replaces Manual mode: you design the pattern on your phone or computer screen and send it to the earring, instead of using the button menus.

Choose your piece

How to send

These steps set up your phone or laptop screen to send the pattern to your earring.

  1. Set up your screen first: turn Auto-Lock off (Settings, General) and the screen brightness all the way up. Turn Night Shift off (iPhone: Settings, Display and Brightness, Night Shift), because it tints the screen and changes the light the earring reads.
  2. Unplug the charger and press the earring’s button until the mode menu shows the 7th light (RECEIVE). It listens for 60 seconds, with the menu’s arm of lights slowly breathing; as soon as it picks up the phone the arm pulses quickly. For two earrings, do this with both.
  3. Open the page for your piece and tap Send. During the countdown, lay the earring flat on the circle, LEDs facing up. Two earrings go side by side, one on each circle.
  4. Keep it still until it blinks 3 times. One blink means it gave up: try again, or choose the Slow sending speed.

Flashing light warning: every send makes the whole screen flash quickly between white and black. Do not use PhiLink if you are sensitive to flashing light; the built-in modes work without it.